D-Link DGS-F1010P-E is now in stock at Mascom International, priced at KSh 9,300 and supplied brand new and sealed. The D-Link DGS-F1010P-E gives you ten Gigabit ports, eight of them delivering IEEE 802.3af/at Power over Ethernet from a shared 96W budget. Two extra Gigabit uplinks connect your NVR, router, or another switch. Flip the Extend switch and ports 1 to 8 push power and data up to 250 metres over Cat5e or Cat6 cable. Collect one from Old Mutual Building, First Floor Room 4, Kimathi Street, Nairobi CBD, or order it for delivery.

Designed for CCTV installers, security firms, estate managers, and warehouse supervisors, the D-Link DGS-F1010P-E handles the hardest part of a camera job, which is getting power to the far corners. Normal Ethernet stops at 100 metres, and a gate camera beyond that point usually needs its own socket and adapter. With the D-Link DGS-F1010P-E, one cable run feeds both video and electricity, so there is no extra wiring on the perimeter wall. Gated homes in Karen and Runda, school compounds, and fuel stations get full coverage without an electrician for every pole.

Where most Nairobi electronics shops sell no-name PoE boxes with vague ratings, Mascom International stocks the genuine D-Link DGS-F1010P-E with published specifications you can plan around. The 96W budget works out to about 12W per port when all eight run together. The 6KV surge protection guards the ports against spikes on long outdoor cable runs. Installers who buy from us report tidier cabinets, shorter installation days, and fewer site revisits after the job is handed over. At roughly KSh 1,163 per powered port, the D-Link DGS-F1010P-E costs less than separate injectors. Order it today for pay-on-arrival delivery.

Yes, the D-Link DGS-F1010P-E replaces eight separate camera power adapters and a plain switch for KSh 9,300. That works out to about KSh 1,163 per powered port. You also save on sockets, extension boards, and electrician time at every camera point. Gigabit ports mean even high-resolution streams move to the recorder without delay. For a typical home, school, or shop with up to eight cameras, it is the simplest complete power and data solution Mascom International stocks at this price.

The D-Link DGS-F1010P-E reaches up to 250 metres on ports 1 to 8 when you switch on Extend mode. Standard Ethernet stops at 100 metres, so this is two and a half times the normal distance. Use good Cat5e or Cat6 cable, because thin copper-clad cable loses power over long runs. Extend mode lowers the link speed to reach that far, which still suits a camera stream. Keep Extend off for short runs so every port works at full Gigabit speed.

The D-Link DGS-F1010P-E powers up to eight IP cameras, one on each PoE port, from a 96W total budget. Shared evenly, that gives each port about 12W, which covers most fixed dome and bullet cameras. PTZ cameras with motors and heaters draw more, so count their ratings before connecting several at once. Add up the wattage on each camera's label and keep the total under 96W. Our team at Mascom International will check your camera list on WhatsApp before you buy.

Choose the D-Link DGS-F1010P-E if you want Gigabit speed on every port, and the DES-F1010P-E only if 100Mbps is enough. Both carry the same long-range PoE idea and eight powered ports. Gigabit matters when you run 4K or 8MP cameras, many streams together, or plan to add access points later. It also gives your recorder faster uplinks for remote viewing. For a new installation, the Gigabit D-Link DGS-F1010P-E is the safer choice for the next few years of camera upgrades.

The D-Link DGS-F1010P-E has four small DIP switches on the front that select Extend, VLAN, QoS, and PoE modes. Extend mode stretches ports 1 to 8 to 250 metres. VLAN mode isolates ports 1 to 8 from each other while each still talks to the uplinks, which blocks camera-to-camera traffic and broadcast noise. QoS mode gives priority to selected traffic so live video stays smooth on a busy network. Set them once during installation, and no software or login is ever needed.

The D-Link DGS-F1010P-E has 6KV surge protection on its ports, which helps against spikes on long outdoor cables. Power cuts are a different problem, because every camera it feeds switches off with it. Plug the switch and your NVR into a UPS, and the whole camera system keeps recording through a KPLC outage. That single step protects evidence at the moment many break-ins happen. Mascom International stocks UPS units sized for a switch, recorder, and eight cameras.

Yes, the D-Link DGS-F1010P-E powers any IP camera that follows the IEEE 802.3af or 802.3at standard, which includes most Hikvision, Dahua, Uniview, and Imou PoE models. Check the camera box or datasheet for 802.3af or 802.3at before connecting. Cheap cameras using passive 12V or 24V power over the cable are not compatible. Analogue HD cameras on coaxial cable also need a DVR rather than a PoE switch. Send us your camera model numbers and we will confirm compatibility first.

Buy the D-Link DGS-F1010P-E if you run up to eight PoE cameras, access points, or IP phones, especially over long cable runs. It suits homes, schools, petrol stations, farms, and small warehouses. Skip it if you need more than eight powered ports; the 16-port D-Link DGSF1210-18PS-E long-range switch handles larger sites. Skip it too if you only connect office computers and printers, because the D-Link DGS-F1016 gives more ports without PoE. Mascom International stocks both, so ask before you buy.

The D-Link DGS-F1010P-E arrives sealed in D-Link retail packaging with the essentials for a camera installation:

Mascom International also sells Cat6 cable, RJ45 connectors, patch cords, wall cabinets, and UPS units, so you can finish the whole installation from one counter.

Mascom International covers the D-Link DGS-F1010P-E with a 12-month warranty against manufacturing defects under normal use. Our Nairobi CBD service desk tests any returned unit and arranges repair or replacement. Keep your receipt as proof of the purchase date.

D-Link DGS-F1010P-E is available now at Mascom International, located at Old Mutual Building, First Floor Room 4, Kimathi Street, Nairobi CBD. Visit our store Monday through Saturday, 9:00 AM to 7:00 PM, to see the D-Link DGS-F1010P-E and check its DIP switches before purchase. Available colour: Black.

Order through any of the following:

Mascom International ships the D-Link DGS-F1010P-E across all 47 Kenyan counties with pay-on-arrival delivery, so you only pay when the switch reaches you. Nairobi and its environs receive same-day delivery. All other major cities and towns, including Nakuru, Eldoret, Kisumu, and Mombasa, receive next-business-day delivery. Mandera, Wajir, Marsabit, Lamu, Tana River, and Turkana receive delivery within 2-3 business days.

Every unit is backed by the 12-month warranty above, with claims handled at our Kimathi Street store.

CCTV installers and property owners across Kenya rely on Mascom International for genuine D-Link networking gear, clear advice on camera power, and after-sales help from a real shop in Nairobi CBD.